Wall code product No. CUTTER

Product name gasket cutter

Specialty

There can be at the site or field assembly of simple cutting out the convenient tool of sealing gaskets for flanges.

I believe this product because of hardcore itself with scale, so it can easily and accurately align dimensions.

I believe through the use of iron (500L), and can be cut to a maximum of 1000mm.

I believe in the chemical plant and oil refinery, ironmaking plant maintenance department, as the assembly plant equipment and device manufacturers and distribution

One of the indispensable tools on the job site of a pipe project, etc., shall be kept standing.

Cutting range

Minimum diameter: 50mm

Maximum diameter: 540mm

In addition, the use of a hardcore sold separately (500L), the maximum diameter of 1000mm can be cut to.

Component commands

Spare parts should be replaced due to prolonged wear and tear.

When individual components are missing, the company also accepts orders for individual components.

(the blade is a 5 piece set of 1 sets, and the company accepts this order.)

Using steps

1. in the first end of the needle core rod moving lower card into the straight or curved needle core needle and the needle core is fixed, fixed with bolts 9. At this point, when the cutting diameter is below 50mm, the core pin is used and the straight pin is used when passing over this range.

2. and 2 root cutter blade and the fixing bolt will be installed in the groove at the end of the moving rod 3 cutter.

3. the end of the needle core moving rod and the cutting knife end moving rod are worn on the support iron rod.

4. the V mark on the needle core end moving rod shall be aligned with the zero scale of the iron rod as shown in figure A, and the screw knob shall be tightened.

5. move the V mark of the moving end of the cutter end to the support iron block, cut the radius of the sealing gasket, size and position, and tighten the knob as well.

6. in cutting, plate in the upper level table or on the ground or carton board, the material on the tile, as shown in figure B to cut, with the left hand hold the needle core end of the rod winding, gently hold the straight or curved needle core and core needle puncture. Hold the cutting edge of the cutting edge with your right hand, press it gently, rotate as a circle, and cut slowly.